Curtain track installation steps

Curtain track installation steps
Curtain track installation for the average person always feel is a very complicated thing, often see the master install curtain track, it seems not so difficult, sometimes meet the Roman rod at home a screw off to please install the master, it seems to be more trouble. The following Xiaobian will tell you about the specific steps and methods.
🔨 Preparing tools
Tools required for the installation of Roman curtain: tape measure, impact drill, small ladder, power cable, 4CM Phillips screw, plastic expansion tube with 4CM Phillips screw, Phillips screwdriver, hand hammer.
🔍 Determine location
First, drill holes in the wall with an impact drill, take the installed support as a standard line, and draw the support positioning line and the hole position line. Generally, the length of the Roman rod is more than 2.5 meters and 3 supports, the middle support is located in the center of the window or wall, and the two ends must be equidistant. The supports at both ends are about 15-20cm away from the wall.
🔧 Installing support
The hole depth is 3.5-5cm. Do not run or tilt the hole. Note: Keep away from wires and water pipes. After finishing the hole, press the plastic expansion tube into the hole. The mounting rod support is fastened by self-tapping, the hanging ring is inserted into the rod, the hanging ring is divided into two parts, and one hanging ring is left at each end; Press the Roman rod into the open support and adjust it so that the distance between the decorative head and the wall is the same.